PDA

View Full Version : Lined/Reversible Jumper Sewalong - dwnld



AdronsCatherine
04-30-2007, 10:18 PM
The pattern I’ve used for this is “Frannie” by Children’s Corner. This can also be applied to sheath-type dresses or a-line jumpers that do not fasten at the shoulders.

I was taught this method by Lezette Thomason of Children’s Corner in a class she held for my local chapter of SAGA (the Smocking Arts Guild of America). The pattern itself provides fairly good instructions for doing this, but I couldn’t wrap my head around it until Lezette showed it to me. I hope this helps someone – I wish you could all be as lucky as I am and live within a couple hundred miles of this amazing woman!!! Since I know that isn’t possible, I have done my best to try to lay it out clearly. If you have any questions, feel free to ask, and I will do my best to answer them for you J



Cut out pattern and trace all markings onto fabric. Sew shoulder seams of outer fabric and lining. Matching shoulder seams, and centers, pin lining to fabric, right sides together.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie01.jpg


Sew around neckline, making sure shoulder seams on lining are even with the shoulder seams on the dress. This particular pattern has a back opening, as the neckline isn’t deep enough to go over the child’s head without it.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie02.jpg

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie03.jpg


Trim and clip seam allowance, being sure to clip the curves so fabric will lay smoothly when turned right side out.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie04.jpg

Turn dress right side out and press neckline well.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie06.jpg


With dress lying flat in front of you, and right side of outer fabric facing up, bring left side of outer fabric over towards center. Then, take left side of lining fabric and bring it under, towards center. You will pull both the outer layer and the lining all the way across, sandwiching the right shoulder area between them.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie08.jpg

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie09.jpg

This is what it should look like from the side:

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie10.jpg


Pin together, making sure that the shoulder seams match, and the other parts of the dress aren’t caught.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie11.jpg

Being careful not to catch any extra fabric, sew the left side together, starting at one side, and continuing the length of the armhole.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie12.jpg

Here it is, sewn from one edge to the shoulder seam. Here you can see the rest of the dress, bunched up in the tube being created by sewing the left armhole.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie13.jpg

After sewing the left armhole, this is what you will have.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie14.jpg

Clip the curves so seam allowances will lay flat when turned right side out, and press well.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie18.jpg

To turn right side out, simply pull the fabric through the left shoulder. The entire dress will come through, and it will look something like this while you are doing it:

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie15.jpg

Repeat with right side, and press both armholes well. Cool, huh!

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie19.jpg

Now, you will press open the underarm seams, and matching front to back, sew the outer dress and the lining. You will do this on both sides, leaving an opening on one side large enough to comfortably accommodate your hand (6” is recommended by the instructions given by Children’s Corner).

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie20.jpg

The easiest way I have found to make this opening is to stitch up to the beginning of the opening, then backstitch to secure your stitches. Change to a long stitch length, and sew to the end of opening area. Switch back to regular stitch length, and backstitch to secure before finishing the seam. This enables you to press the entire seam open neatly and evenly, making it easier to sew closed when you are done.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie21.jpg

Once you have sewn these seams and pressed them open, remove the basting threads from the opening.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie23.jpg

Smooth the lining over the dress, with the opening facing you.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie24.jpg

Reach through the opening, matching side seams, and pin lining to outer fabric at the hem, right sides together.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie26.jpg

At this point, I like to stitch a few inches at one of the side seams so I don’t lose my bearings. Continue to pull the whole dress through the opening, and sew around the entire hemline, matching centers and seams.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie28.jpg

It will look like a very confused fabric tunnel when you get done with this part! You will now press the hemline that you have just sewn.

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie30.jpg

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie29.jpg

The last step is to pull the dress back through the opening, and press again, making sure the fabric is even and there are no areas that are bunched up. Viola!

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie31.jpg

You now have a fully lined and/or reversible jumper that just needs a few stitches to close up the opening you used for turning the dress. Add a button and a loop to the back opening, and you are done!

http://i10.photobucket.com/albums/a140/elliebutton/Frannie/Frannie33.jpg

Notes:

If you are using the Frannie pattern, and putting the drawstrings in the sides, be sure to add buttonholes as called for by the pattern.

When using this method for a narrower (sheath) style, or a regular a-line jumper, you won’t have to worry about the casings and elastic or drawstrings. The Frannie pattern has a lot of extra fullness built into the sides and uses these to pull it in.

I personally find the ties to be quite a nuisance with toddlers and preschoolers, so I sew the casings as directed after finishing the hem, and insert elastic, sewing securely at front and back ends of the casing. I use approximately 4 ½” of 3/8” elastic on each side to give it a close, fairly stretchy fit. After inserting the elastic, I hand stitch the inner opening closed, and tack ribbon or a bias tube to the side seams over the casing to give it the look of a drawstring without the hassle.

I have used narrower elastic (1/4”, as called for by the pattern), and found that Ellie really likes to pull her arms into her dress and see how far she can stretch it! 3/8” elastic is much firmer, and has less give, so it’s not as tempting (or fun LOL!).

With the real drawstrings, the gathers weren’t nearly as nice and even, and Ellie would untie them and pull the sides out all the way, causing her to look like she was wearing a tent…!

frogsnladybugs
05-01-2007, 07:06 AM
ok cath...you better come show me in person how you're doing that b/c i'm still lost lol

khogue
05-01-2007, 10:05 AM
I don't have the Frannie pattern but have been curious about the construction, thanks for the great sewalong!

Einen
05-01-2007, 02:52 PM
I'm bookmarking this. Thanks!

elfinthegarden
05-01-2007, 03:09 PM
Are you saying that you sew the side seams of the lining and the side seams of the outer but leave a gap in the lining which you use to find the hem and sew the hem through that gap as it were?

AdronsCatherine
05-02-2007, 09:41 AM
Are you saying that you sew the side seams of the lining and the side seams of the outer but leave a gap in the lining which you use to find the hem and sew the hem through that gap as it were?


:yes: You've got it! It's a little mind boggling, but it works so beautifully...

And, Heather, I will definitely plan a trip out there in the next couple of weeks :D

IndigoKiwi
05-02-2007, 09:53 AM
Thank you thank you thank you...I was trying to remember how to do this and was looking for my notes! This is EXACTLY what I needed to know for the dress I botched on Sunday! I am armed and dangerous for the next iteration though! :D

seauxhappy
05-02-2007, 09:58 AM
Great Sew-a-long !!! Thanks

AdronsCatherine
05-02-2007, 10:00 AM
So glad I could help! I can't wait to see what you come up with :)

khogue
07-23-2007, 09:00 AM
I finally picked up Butterick 4161 for Lillie over the weekend and plan to fully line it using this GREAT sewalong!

elfinthegarden
05-10-2008, 06:29 PM
It's taken me almost exactly a year to do this but I did it tonight with a dress from a japanese pattern book instead of binding the edges and it worked like a dream! It's all a bit inside-outy at times but it's like magic once it's done!

Thank you:cheerful:

bluangelgrl79
02-24-2010, 05:44 PM
Realizing that I'm way behind on this post... Ok, so I'm at the point that I'm pulling the main fabric out thru the side-seam-hole and as I'm pinning and pulling it all ends up kinda twisted(?) at the hole on the inside with the main fabric. What am I doing wrong, am I missing a step or something? Can anyone shed some like for me?

AdronsCatherine
02-25-2010, 07:16 AM
Hmmmm....

How about trying to turn it right-side out without pinning any of the hem area. It should make that step a lot easier, and should let you get it turned the right way without any twisting.

If that doesn't help any, PM me, and I'll try to see if I can walk you through it ;)